Table of Contents
Advertisement
10 www.aeg.com
You must adjust the water soft-
ener manually and electronically.
Manual adjustment
Electronic adjustment
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
"Setting and starting a programme".
2. Press and hold, at the same time, De-
lay and Start until the indicators of
start to flash.
3. Press Program,
• The indicators of
6.2 Filling the salt container
,
and
and
go off.
Turn the water hardness dial to the posi-
tion 1 or 2.
• The indicator of
ues to flash.
• The display shows the current set-
ting of the water softener. E.g.
= level 5.
4. Press Program again and again to
change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
1.
Turn the cap counterclockwise and
open the salt container.
2.
Put 1 litre of water in the salt con-
tainer (only for the first time).
Fill the salt container with dishwash-
3.
er salt.
4.
Remove the salt around the opening
of the salt container.
5.
Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
contin-
Advertisement
Table of Contents
