Download Print this page

RIDGID WD1255BR0 Owner's Manual: Filter Removal And Installation

45 liter/12 u.s. gallon wet/dry vac.
Hide thumbs

Advertisement

SP6823 WD1255 PSE-BRZ

Filter Removal and Installation

Removal and Installation
of the Qwik Lock™ Filter
Filter Removal:
1. Hold the filter tabs of the Qwik Lock™
filter in each hand.
2. With one thumb on the Qwik Lock™
stud, which protrudes through the
integrated filter plate, lift up on the filter
tabs while pushing down on the stud.
3. This action will cause the filter to
release from the filter cage. Slide filter
off cage.
Filter Installation:
1. Carefully slide the Qwik Lock™ filter
over the filter cage and press down on
the outside edge of the filter until the
rubber gasket on the bottom of the filter
seats securely around the base of the
filter cage and against the lid.
2. Align the small center hole in the top of
the filter over the Qwik Lock™ stud on
the filter cage. Press firmly on top of
the filter near the stud to allow the filter
to snap over the ball on the end of the
stud. The filter is now attached.
NOTE: Failure to properly seat the
bottom gasket could result in debris
bypassing the filter.
!
WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
4/17/12
1:54 PM
37
Page 37
Integrated Filter
Plate with Center
Hole
Filter
Tabs (2)
Filter
Cage
Lid
PUSH
DOWN
PULL
UP
Rubber
Gasket at
Bottom of
Filter
(cutaway
view)
Qwik
Lock™
Stud

Advertisement

Table Of Contents

   Related Manuals for RIDGID WD1255BR0

This manual also for:

Wd1256br0

Comments to this Manuals

Symbols: 0
Latest comments: