Sanyo VCC-HD2500P Service Manual page 10

Adjustment location: CCD Black of computer screen
Measuring location: Computer screen
Measuring equipment:
Subject: Lens of VHJ-0196
Adjusting method:
1. Set a distance of 0.5 - 1.0 cm between the pattern box and
the camera.
2. Connect the camera's USB terminal to the computer'
USB connector.
3. It turns on power while pushing the FAR button and the
SET button of the operation panel.
4. Double-click on the DscCalDi.exe.
5. Select "CCD Black" on the LCD "Test", and click the "Yes".
6. After the adjustment is completed, the number of defect
will appear.
7. Click the OK.
5. Focus Assistance Drive Adjustment
Camera
Adjustment location: Focus of computer screen
Measuring location: Computer screen
Measuring equipment:
Subject: Lens of VHJ-0197 and VHJ-0198,
Siemens star chart
Note:
Do not vibrate during the adjustment.
Lens is set 2m and F1.8.
Adjustment method:
1. Set the siemens star chart 200 cm from lens surface
so that it becomes center of the screen (Illumination
above the subject should be 600 lux or more.).
2. Connect the camera's USB terminal to the computer'
USB connector.
3. It turns on power while pushing the FAR button and the
SET button of the operation panel.
4. Double-click on the DscCalDi.exe.
5. Click the "Focus", and Click the "Yes".
6. Lens adjustment value will appear on the screen.
7. Click the OK.
Siemens
200 cm
star chart
Adjustment value determination is effectuated using below val-
ues.
The adjustment values fulfill the conditions below, they are
determined as within specifications.
Adjustment value determination
AF_I_WIDE = 0 ± 2500, AF_I_MID1 = Reference value,
AF_I_MID2 = 0, AF_I_MID3 = 0, AF_I_MID4 = 0,
AF_I_MID5 = 0, AF_I_MID6 = 0, AF_I_TELE = 0,
QR_Z_WIDE = 0, QR_F_I_WIDE = 0, QR_F_I_TELE = 0,
QR_Z_AORI = 0, QR_F_I_AORI = 0, IRIS_GAIN = 0,
IRIS_OFFSET = 0
6. CS Mount Optical Axis Adjustment
Adjustment location: Privacy Mode of computer screen
Measuring location: Computer screen
Measuring equipment:
Subject: Lens of VHJ-0196
Preparation:
Lens is set on TELE edge/NEAR edge.
Adjusting method:
1. Connect the camera's USB terminal to the computer'
USB connector.
2. It turns on power while pushing the FAR button and the
SET button of the operation panel.
3. Double-click on the DscCalDi.exe.
4. Select "Privacy Mode" on the LCD "Test", and click.
5. Area display is made on (Check is put in Privacy Mode).
6. Four corners of mechanical vignetting with the lens are
adjusted to enter between double frames by "Up",
"Down", "Left" and "Right".
7. "WIDE" is clicked and the adjusted value is preserved.
8. Click the OK.
Privacy mask calibration
Privacy mask
Privacy Mode
Left
- -
10
Tele
Wide
Up
Right
Down
OK