Brake Pads Removal; Pads Wear; Pads Cleaning; Pads Installation - Husqvarna TC - TE 449 2013 I.E. Manual

BRAKE PADS REMOVAL

- Remove clips (1).
- Slide out pin (2).
- Remove pads.
*:
WARNING
Do not work the brake lever or pedal
while removing the pads.

PADS WEAR

Check brake pad wear.
Service limit " A" is: 3.8 mm (0.15 in).
If service limit is exceeded, always replace the pads in pairs.
FRONT
2
1
SPECIFICATIONS - OPERATION - MAINTENANCE
EN - 46

PADS CLEANING

Be careful that no brake fluid or any oil gets on brake
pads or discs. Clean off with alcohol any fluid or oil that
inadvertently gets on the pads or disc. Replace the pads
with new ones if they cannot be cleaned satisfactorily.

PADS INSTALLATION

- Install new brake pads.
- Reassemble the two pins (2) and the clips (1).
WARNING*:
Do not attempt to ride the motorcycle
until the brake lever or pedal are fully
effective. "Pump" with the brake lever
or pedal until the pads are against the
discs. The brake will not function on the
first application of the lever or pedal.
REAR
1
1
1
2 FRONT REAR