Scanning Sequence Examples; Errors While Scanning; User Preferences And Miscellaneous Options - Parameter Defaults - Motorola Symbol DS6707 Product Reference Manual

Motorola symbol ds6707 digital imager scanner
Hide thumbs Also See for Symbol DS6707:
Table of Contents

Advertisement

4 - 2
Symbol DS6707 Digital Imager Scanner Product Reference Guide

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code listed under
issues a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats, require scanning several
bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences and Miscellaneous Options - Parameter Defaults

Table 4-1
lists defaults for user preferences parameters. There are two ways to change the default values:
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, see the
Download data through the device's serial port using SSI. Hexadecimal parameter numbers appear in this
chapter below the parameter title, and options appear in parenthesis beneath the accompanying bar codes.
See the Simple Serial Interface (SSI) Programmer's Guide for detailed instructions for changing parameters
using this method.
NOTE See
miscellaneous default parameters.
User Preferences Parameter Defaults
Table 4-1
Parameter
User Preferences
Set Default Parameter
Parameter Scanning
Beeper Tone
Beeper Volume
Power Mode
Time Delay to Low Power Mode
Trigger Mode
Picklist Mode
Decode Session Timeout
Timeout Between Decodes, Same Symbol 89h
Appendix A, Standard Default Parameters
Parameter
ECh
91h
8Ch
80h
92h
8Ah
F0h, 92h
88h
Beeper Tone on page
Set Default Parameter on page
for all user preferences, hosts, symbologies, and
Default
Number
Set All Defaults
Enable
Medium
High
Continuous On
1 Minute
Auto Aim
Disabled Always
9.9 Sec
0.6 Sec
4-5. The digital imager scanner
4-4.
Page
Number
4-4
4-5
4-5
4-6
4-6
4-7
4-8
4-9
4-10
4-10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents