IBM ThinkPad Dock II Hardware Maintenance Manual page 59

Symptom or error
0182
Bad CRC2. Enter BIOS Setup
and load Setup defaults.—The
checksum of the CRS2 setting
in the EEPROM is not correct.
0185
Bad startup sequence settings.
Enter BIOS Setup and load
Setup defaults.
0187
EAIA data access error—The
access to EEPROM is failed.
0188
Invalid RFID Serialization
Information Area.
0189
Invalid RFID configuration
information area—The
EEPROM checksum is not
correct.
0190
Critical low-battery error
0191
System Security—Invalid
Remote Change requested.
0192
System Security—IBM
Embedded Security hardware
tamper detected.
0199
System Security—IBM Security
password retry count exceeded.
01C8
Two or more modem devices
are found. Remove all but one
of them. Press <Esc> to
continue.
01C9
More than one Ethernet devices
are found. Remove one of
them. Press <Esc> to continue.
ThinkPad R50/R50p and R51 Series
Symptom-to-FRU index
FRU or action, in sequence
1. Run IBM BIOS Setup
Utility. Press F9, and
Enter to load the default
setting. Then save the
current setting by
pressing F10.
2. System board.
1. Run IBM BIOS Setup
Utility. Press F9, and
Enter to load the default
setting. Then save the
current setting by
pressing F10.
System board.
System board.
System board.
1. Charge the battery pack.
2. Battery pack.
1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
System board.
1. Run IBM BIOS Setup
Utility, and then save the
current setting by
pressing F10.
2. System board.
1. Remove either a Mini-PCI
Card or a modem
daughter card. Otherwise,
press Esc to ignore the
warning message.
2. System board.
1. Remove the Ethernet
device that you installed;
or press Esc to ignore the
warning message.
2. System board.
55