Table of Contents
Advertisement
SETTINGS
High speed electronic shutter setting
Normally, the speed setting switches for the high speed electronic
shutter are all set to the down (OFF) position. This sets the electronic
shutter speed to 1/50 sec. The switches can be set as indicated in
table A to select one of the 8 speeds available.
CAUTION:
•
When using the high speed electronic shutter, the switch 4 must
be set to the down (AI) position.
•
Using the high speed electronic shutter indoors with low lighting,
will give darker pictures. In such a case, add some lights to make
sure the lighting is sufficient. If the lighting is very bright, pay
attention to the light angle in order to avoid or minimize the
smear phenomenon effect.
Table A (switch 1 ~ 3)
1
2
3
4
1/50
1/120
1/250
1/500
1
2
3
1
2
3
1
2
3
1
11
English
5
6
7
1/1000
1/2000
1/4000
2
3
1
2
3
1
2
3
1
2
3
(Unit: sec.)
Iris function setting
This should normally be set to the down (AI) position.
Use a manual or fixed iris lens and set the lens aperture to the
shortest F stop. Set the switch 4 (IRIS) to the up (EI) position.
4
Note:
Please refer to the specifications for dynamic range of the electronic
iris.
CAUTION:
8
•
The electronic iris is suitable for normal indoor use. When the
1/10000
switch 4 (IRIS) is set to the up (EI) position, do not use an auto-iris
lens.
1
2
3
•
If used under fluorescent light, the image may flicker. In such a
case, change to incandescent lighting or set the switch 4 (IRIS) to
the down (AI) position and use an auto-iris lens.
•
When shooting bright subjects, pay attention to the light angle in
order to avoid or minimize the smear phenomenon effect.
Advertisement
Table of Contents
