How Is The Dematik Pi-240 Reg Regeneration Agent Refilled - Winterhalter UC Series Operating Instructions Manual

8.4 How is the DeMatik Pi-240 Reg regeneration agent refilled?

The DeMatik PI-240 Reg regeneration agent can irritate the eyes and skin
Wear gloves when you are filling with regeneration agent.
If you get regeneration agent in your eyes or on your skin: Flush the regeneration agent with
Caution
plenty of water. Also read the safety data sheet, which is available on the Internet.
Use only Winterhalter DeMatik Pi-240 Reg Regeneration agent!
Do not fill with chemicals such as a cleaning or rinsing agent. Do not fill with regenerating salt
for water softener. This will result in damage to the built-in partial demineraliser. Call a
Winterhalter service technician if you have added the wrong product
Run a wash cycle after filling with regeneration agent!
Run a wash cycle immediately after filling to rinse off any remaining residue of regeneration
agent. Do not remove regeneration agent residue by hand.
Open the machine door and remove
the rinsing basket from the
machine.
Open the screw cap on the
regeneration agent reservoir.
Refit the lower rotating wash field
and snap it into position.
Check that the rotating wash field
turns easily.
Inbuilt Partial Demineraliser DeMatik Pi-240 (optional)
Unlatch the lower rotating wash
field.
Place a funnel in the filler opening.
Fill with a bottle (=1.5 kg) of
DeMatik Pi-240 Reg powder
regeneration agent.
Remove the funnel.
If necessary, fill up the reservoir
with water.
The cap of the DeMatik Pi-240 Reg
regeneration agent bottle is still
needed. See Chapter 8.5
Remove the lower rotating wash
field from the machine.
Screw the cap back on reservoir
without tilting it
11