List of Viewer Messages
Messages Displayed in the Information Field
Messages displayed in the information field of the viewer are classified into the following three types.
Icon
Category
Information Message
Warning Message
Error Message
Information Messages
Message
Connection closed by the camera.
Audio connection has been closed.
Camera control gained.
Camera control lost.
Use the menu displayed by right-clicking to exit the full
screen mode.
Recording to memory card aborted.
The connection was terminated because the password
has been changed.
Message
{n}fps Pan: {p} Tilt: {t} Zoom: {z}
The connection was terminated because the image has
been flipped.
Message
{n}fps Pan: {p} Tilt: {t} Zoom: {z}
{n}fps
Help messages on various buttons, pull-down lists, etc., as well as frame rate and other
information from the camera are shown.
A message will be displayed notifying the user when camera control privileges cannot
be obtained, the audio session stops, etc.
Displayed when a system error occurs in the viewer.
The camera was disconnected.
The video session has continued after the audio session was disconnected.
Displayed when camera control is obtained. You can operate the camera.
Displayed when camera control is released. You cannot operate the camera
until you get camera control privileges again.
When switched to full screen mode
When recording to memory card was completed successfully
When the password of the account used to connect to the camera was
changed during camera connection and then any WV-HTTP command was
issued
Communicating with the camera normally
When the video was flipped during camera connection (camera connection
is terminated when a video is flipped)
Communicating with the camera normally (when Digital PTZ is enabled)
Communicating with the camera normally (when Digital PTZ is disabled)
Explanation
Explanation
Explanation
Explanation
7
153