Service Point - Hitachi 42PD8900TA Service Manual

Hide thumbs Also See for 42PD8900TA:
Table of Contents

Advertisement

3. Service points
Lead free solder
This product uses lead free solder (unleaded) to help preserve the environment. Please read these
instructions before attempting any soldering work.
Caution: Always wear safety glasses to prevent fumes or molten solder from getting into the eyes. Lead
free solder can splatter at high temperatures (600˚C).
Lead free solder indicator
Printed circuit boards using lead free solder are engraved with an "F."
Properties of lead free solder
The melting point of lead free solder is 40-50˚C higher than leaded solder.
Servicing solder
Solder with an alloy composition of Sn-3.0Ag-0.5Cu or Sn-0.7Cu is recommended.
Although servicing with leaded solder is possible, there are a few precautions that have to be taken. (Not
taking these precautions may cause the solder to not harden properly, and lead to consequent malfunctions.)
Precautions when using leaded solder
Remove all lead free solder from soldered joints when replacing components.
If leaded solder should be added to existing lead free joints, mix in the leaded solder thoroughly after the
lead free solder has been completely melted (do not apply the soldering iron without solder).
Servicing soldering iron
A soldering iron with a temperature setting capability (temperature control function) is recommended.
The melting point of lead free solder is higher than leaded solder. Use a soldering iron that maintains a high
stable temperature (large heat capacity), and that allows temperature adjustment according to the part being
serviced, to avoid poor servicing performance.
Recommended soldering iron:
Soldering iron with temperature control function (temperature range: 320-450˚C)
Recommended temperature range per part:
Part
Mounting (chips) on mounted PCB
Mounting (chips) on empty PCB
Chassis, metallic shield, etc.
SUBPOWER PWB (Subpower PWB, Filter PWB, Terminal PWB)
SOUND PWB (Audio PWB, Control PWB, SW PWB)
FC PWB
MAIN PWB (Main PWB, LED PDP PWB, Swivel PWB)
Readjustment Power supply voltage
When a PANEL or a Power Unit is exchanged, power supply voltage needs to be adjusted. Please adjust to
make the values of Va and Vs of as should on the label currently stuck on the panel back upper parts.
Adjustment is performed by VR in the power supply unit. Please refer to the procedures of "Va" and "Vs"
adjustments on 33page.
42PD8900TA
Soldering iron temperature
320˚C±30˚C
380˚C±30˚C
420˚C±30˚C
The PWB assembly which has used lead free solder
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents