Kenwood CK 704 Instructions For Use Manual page 25

INSIDE OF OVEN
– The oven should always be cleaned
after use when it has cooled down.
– Remove and refit the side runner
frames as described on the next
chapter.
– The cavity should be cleaned using a
mild detergent solution and warm
water.
– Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations
and testing a small sample of the
oven cavity.
– Abrasive cleaning agents or scouring
pads/cloths should not be used on
the cavity surface.
– Side runner frames, tray and rack can
be removed and washed in the sink.
NOTE: The manufacturers of this appli-
ance will accept no responsibility for
damage caused by chemical or abrasive
cleaning.
FITTING THE OVEN OUT
– Hang up the wire racks "G" on the oven
walls (fig. 8.8).
– Slide the required shelf and tray etc. in
using the guides (fig. 8.9).
The rack must be fitted so that the safe-
ty catch, which stops it sliding out, faces
the inside of the oven (fig. 8.9).
– To dismantle, operate in reverse order.
G
Fig. 8.8
Fig. 8.9
25