Table of Contents
Advertisement
Spitfire - EP -
Item code: BH127
Plastic parts of pushrod.
18
.
Cut.
Instruction Manual
C/A glue
Bottom side
Rudder
pushrod.
INSTALLING THE RECEIVER AND BATTERY.
1. Plug the servo leads and the switch
lead into the receiver . You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead
when you are installing the wing . Plug the
battery pack lead into the switch.
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape to
hold the foam in place.
3. Position the battery pack and receiver
is as pictures below.
Do not permanently secure the re-
ceiver and battery until after balancing the
model.
4) Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver , for
the antenna to exit.
Tie wrap.
E l e v a t o r
pushrod
easier
Advertisement
Table of Contents
