Saw Chain Filing And File Gauges - Husqvarna 543 XP Operator's Manual

Recommended cutting equipment for Canada
The following is a list of recommended cutting equipment for chainsaws Husqvarna 543 XP and 543 XPG. The
combinations of powerhead, guide bar and saw chain meet all requirements outlined in the CSA Z62.1-11 Chainsaws
and Z62.3-11 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
The following cutting attachments are approved for the models Husqvarna 543 XP and 543 XPG.
Length, inch Pitch, inch
13
15
0.325
16
18
13
15
0.325
16
18
Note: For the chains above you are free to choose between 0.050" and 0.058" gauge drive link for the corresponding
bar, see the table below.
0.050"/1,3 mm
0.058"/1,5 mm
Saw chain filing and file gauges
TECHNICAL DATA
Guide bar
Gauge, inch Max. nose radius Type
0.050 10T
0.058 10T
H30 H22
- H25
Saw chain
Drive link count
56
64
Husqvarna H30
66
72
56
64
Husqvarna H25
66
72
English – 39