Auto-White Balance - GRASS VALLEY LDK 3000+ User Manual

5.6.3 Auto-white balance

If the reference color temperatures do not match your lighting conditions carry out the auto-
white procedure as follows:
1. Use the Color temperature switch to select one of the memory positions FL50, FL60,
AW1 or AW2 in which to store the measured color temperature value.
2. Press once on the White balance switch at the front of the camera to start the automatic
white balance procedure. The following appears in the viewfinder:
-
3.2
☞ ☞
Note Note
If you did not select one of the memory positions FL50, FL60, AW1 or AW2, the 'Precondition
fail' message appears in the viewfinder.
3. Point the camera so that the reference white surface is between the two small black
boxes.
4. Press the White balance switch again to start the measurement procedure. A message
indicating that the process is runnning appears.
-
3.2
LDK 3000+ High-Definition Camera Head User's Guide (v1.0)
SW1 SW 2 Std
File
+ +
Color temperature
selection switch
+ ++ REC MED IA BAT T ND/RE FOC+
AWHITE: window
4.7 5.6 7.5 FL AW1 AW2
!
++ REC MED IA FOC+
+ BAT T ND/RE
AWHITE: running
4.7 5.6 7.5 FL AW1 AW2 !
Chapter 5 - Video setup
V Exp. White Clean
VTR start
shift Time Bal. scan
Select
Audio Level
Auto white balance
switch
55