KVH Industries TracVision C3 Owner's Manual page 77

A Guide to TracVision C3
E-6
Report RF Tracking Parameters
Function: reports all RF tracking parameters for primary &
secondary satellites*
Command: @SATCONFIG
Response: F,x,fffff,S,C,ID,P,B,D <cr>
Where: x =
fffff = Frequency in MHz (00000 and 10700 to
S = Symbol rate in Mbit/Sec (1000 to 29999)
C = FEC code rate (valid rates = 12, 23, 34, 56,
ID = Satellite Network ID in hexidecimal format
P = LNB Polarization (v = vertical, h = horizontal,
B = the LNB down conversion frequency (l = low,
D = decoding type (0 = test, 1 = DSS-A,
* This command dumps all eight combinations of the Satellite/
Freq/Sym/FEC/ID/POL/Band/Decode currently stored in RAM.
Set RF Tracking Parameters
Function: sets RF tracking parameter
Command: @SATCONFIG,X,N,F,S,C,ID,P,B,D<cr>
Response: Echoes the input data
Where: @SATCONFIG = directs data to the RF Board
X = satellite location A or B
N = satellite table # (98 & 99 are slots for user-
F = frequency in MHz (either 00000 or a range
S = the satellite transponder symbol rate in
C = the FEC code (e.g., 12, 23, 34, 56, 67, 78)
ID = the satellite network ID in hexidecimal format
P = the LNB polarization (v = vertical,
B = the LNB down conversion frequency (l = low,
D = decoding type (0 = test, 1 = DSS-A,
Satellite (a = Primary, b = Secondary)
12700)
67, 78)
(valid range = 0x0000 to 0xffff hex)
r = right, l = left)
h = high, u=USA)
2 = DSS-B, 3 = DVB)
configured satellites)
from 10700 - 12700)
Mbit/second (01000 - 29999)
(0x####)
h = horizontal, r = right, l = left)
h = high, u = US)
2 = DSS-B, 3=DVB)