HDMI Color Range Adjust the color range of the HDMI image data to correct color display
Downloaded From projector-manual.com Acer Manuals
Front-Desktop: The factory default setting.
Rear-Desktop: When you select this function, the projector
reverses the image so you can project from behind a translucent
Rear-Ceiling: When you select this function, the projector
reverses and inverts the image at same time. You can project from
behind a translucent screen with ceiling mounted projection.
Front-Ceiling: When you select this function, the projector
inverts the image for ceiling-mounted projection.
Use this function to choose your desired aspect ratio.
Auto: Keep the image with original width-higth ratio and maxi
mize the image to fit native horizontal or vertical pixels.
4:3: The image will be scaled to fit the screen and displayed using
a 4:3 ratio.
16:9: The image will be scaled to fit the width of the screen and
the height adjusted to display the image using a 16:9 ratio.
Automatically adjusts vertical image.
Adjust image distortion caused by tilting projection. (±40 degrees)
<Note> The Manual Keystone function is unavailable under Auto
Keystone setting to "On".
Adjusts the sharpness of the image.
to decrease the sharpness.
to increase the sharpness.
to move the image left.
to move the image right.
to move the image down.
to move the image up.
"Frequency" changes the projector's refresh rate to match the
frequency of your computer's graphics card. If you can see a vertical
flickering bar in the projected image, use this function to make the
Synchronizes the signal timing of the projector with the graphics card.
If you experience an unstable or flickering image, use this function to
Auto: Automatically adjust by information from player.
Limited Range: Prosess the input image as limited color range data.
Full Range: Prosess the input image as full color range data.