Seeting Options In The Display - KTM 640 LC4 Owner's Manual

1 10 sec
1
2
2
2
Setting options in the display
KILOMETERS OR MILES.
You can have the speed and distance shown in kilometers or miles in the
display. The display can be adapted to the respective country on long-
distance trips.
To switch from kilometers to miles, switch on the ignition and press the
1
MODE button for approx. 10 seconds. The km/h display will switch to
mph. The speed and the stored distances will be converted and displayed in
miles.
To return to kilometers, proceed as described above.
CLOCK
Switch on the ignition and change to the CLOCK mode.
1
Simultaneously press MODE
start to blink. Use the MODE button to set the hours and the SET button to
set the minutes.
The press the MODE and SET buttons simultaneously.
NOTE: 0:00 will be displayed if the clock is not supplied with electricity. This
can be caused by a defective fuse or a fault in the board electric system (see
Troubleshooting).
TRIP 1
The trip meter 1 runs continuously and counts up to 999.9. It can be used
to measure the length of a certain route on a trip or the distance between
two refueling stops.
To return the trip meter 1 to zero, switch on the ignition, change to the
TRIP 1 mode and press the SET button.
RESETTING TRIP 2
The trip meter 2 runs continuously and counts up to 999.9. It can be used
similarly to TRIP 1 or together with a switch available as an accessory (see
below) for trips according to a roadbook.
To return the trip meter 2 to zero, switch on the ignition, change to the
TRIP 2 mode and press the SET button.
NOTE: A Tripmaster switch (Part no. 582.14.069.044) is available as an
accessory and enhances the trip meter 2 functions. You can correct the
displayed route by increasing or decreasing in increments of 0.1. For
example, if you have taken the wrong road when driving according to a
roadbook, you can easily correct the display to correspond to the roadbook
again. It can also be used to change the display modes. The switch is moun-
ted on the handlebars so that you can keep your hands on the handlebars.
TRIP F
When the fuel level reaches the reserve mark, the display will automatically
switch to TRIP F and begin to count (no matter which display mode was
active before). At the same time, the fuel warning lamp will start to blink.
You will still have enough reserve fuel for at least 35 kilometers.
After refueling, it will take approx. 3 minutes for TRIP F to automatically
reset to 0 and return to the previous display mode.
NOTE: To use up the reserve fuel in the tank, move the fuel cock to the RES
position by hand.
2
and SET . The numbers on the clock will
7