Replacing The Light Bulbs; Freezer Light; Refrigerator Lights - GE 20 Owner's Manual And Installation Instructions

Replacing the light bulbs.

Turning the control to the 0 (off) position does not remove power to the light circuit.
Appearance may vary
Lights are behind
crisper drawers

Refrigerator Lights

CAUTION:
Light bulbs may
be hot.
Unplug the refrigerator.
To remove the light shield, grasp the
shield at the back and pull out to release
the tabs at the back.
Rotate the shield down and then forward
to release the tabs at the front of the
shield.

Freezer Light

CAUTION:
Light bulbs may
be hot.
Unplug the refrigerator.
Remove the freezer basket for access.
The bulb is located at the rear of the
freezer inside a light shield.
To remove, grasp the shield at the top
and pull out to release the tabs at the
bottom.
Middle Lights
CAUTION:
Light bulbs may
be hot.
Unplug the refrigerator.
The bulbs are located behind the crisper
drawers. To remove the drawers, lift up
slightly while pulling the drawer past the
stop location.
Replace the bulbs with appliance bulbs
of the same or lower wattage.
Replace crisper drawers by sliding them
gently back onto the tracks while lifting
up slightly.
Plug the refrigerator back in.
GEAppliances.com
After replacing with an appliance bulb
of the same or lower wattage, replace
the shield.
Plug the refrigerator back in.
NOTE: Appliance bulbs may be ordered from
GE Parts and Accessories, 800.626.2002.
After replacing with an appliance bulb
of the same or lower wattage, replace
the shield and freezer basket.
Plug the refrigerator back in.
Light Bulbs
15