Inatallation And Accessory Parts - Haier BD-103GC Service Manual

Chest freezer
Hide thumbs Also See for BD-103GC:
Table of Contents

Advertisement

INATALLATION AND ACCESSORY PARTS

Unpacking Your Freezer
1.Remove all packaging material; this includes the foam base and all
adhesive tape holding the freezer accessories inside and outside.
2.Inspect and remove any remains of packing, tape or printed materials
before powering on the freezer.
Adjusting Your Freezer
1.Your freezer is designed for freestanding installation only. It should not be
recessed or built-in.
2.Place the freezer on a floor strong enough to support it fully loaded.
3.When moving the freezer, never tilt it more than a 45-degree angle. This
could damage the compressor and the sealed system.
4.If the freezer is tilted let it stand in an upright position for at least 24 hours
prior to plugging. This is to allow the refrigerant to settle.
·Proper Air Circulation
To assure your freezer works at the maximum efficiency it was designed
for, you should install it in a location where there is proper air circulation,
Plumbing and electrical connections.
The following are recommended clearances around the freezer:
Sides..............2"(50mm)
Top. ...............2"(50mm)
Back..............2"(50mm)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents