CLASSIC 24 RANGES OF GLASS & DISHWASHERS
The first 3 pages are for training and identifying the interlock circuit.
Page 1
Select Position
Where you select a cycle by pressing the cycle switch.
The switch will illuminate but will not start until the machine is up to
temperature
EXCEPT H7 with '4 MIN' selected
All machines with Heat interlock removed.
Page 2 Start Position
The machine is up to temperature and the cycle will start (Orange cable to
timer)
We have detailed the '2/4 MIN' switch, which indicates either a signal from the
thermostats (White Cable) or constant power (Brown Cable)
Page 3 Changeover Position
When the machine starts to rinse a single from the timer (RED Cable)
changes the circuit so that when the cycle is completed the machine will stop
and you have to select a cycle again to start the machine
Page 4 Fault Finding – Help on possible faults, which may occur
REMOVING HEAT INTERLOCK – if necessary?
IDENTIFY
On the 'CYCLE RELAY' (inner relay of two) there is a WHITE cable with a
'Black' terminal sleeve, and floating BROWN cable with a Black sleeve
Change the cables over so the BROWN cable is on the Relay and the white
cable floating.
Put the clear rubber cover from the BROWN over the end of the WHITE cable
for safety.
PAGE 26