Sony KV-14LT1B Service Manual page 16

Fd trinitron
Hide thumbs Also See for KV-14LT1B:
Table of Contents

Advertisement

Geometry Adjustment.
Preparation:
Before starting this adjustment, adjust the horizontal and vertical
static convergence.
1.
Remove the deflection yoke spacer.
2.
Tilt the deflection yoke as indicated in the figure below and
optimise the geometry.
Tilting the DY Up and Down will balance the upper and
lower pin adjustment.
Tilting the DY Left and Right will balance the H-Trap
adjustment.
3.
Re-install the deflection yoke spacer.
Tilt Direction
HTIL Adjustment
Deflection Yoke
TLH pieces
HTIL correction can be performed by adding a TLH correction
assembly to the Deflection yoke.
YCH Adjustment
YCH VR
+
+
Deflection Yoke
TLV Adjustment
TLV VR
+
+
Deflection Yoke
Screen Corner Convergence
If you are unable to adjust the corner convergence properly, this
can be corrected with the use of permalloy magnets.
a
b
a-d: screen-corner
convergence defect
d
c
a
Install the permalloy assembly
for the area that needs correcting.
b
Permalloy Assy
X-4387-214-1
c
d
Convergence adjustment with permalloy
Page 16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents