Clean The Drain Pump Filter - LG WD-1 Series Service Manual

ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER ASSEMBLY
Rotor
Bolt
Hinge,
Damper

Clean the drain pump filter

0 1 0
Open the lower cover cap ( ) by
using a coin. Turn the drain plug
( ) to pull out the hose.
(ROTOR ASSEMBLY)
(1)
(STATOR ASSEMBLY)
Damper
(DAMPER)
1
Unplug the drain plug (
the water flows out,
At this time use a vessel
to prevent water from flowing on the
floor. If the water does not flow any
more, turn the pump filter (
open to the left.
Remove the BACK COVER.
Unscrew the bolt to pull out the ROTOR assembly.
Disconnect the wiring connector.
Unscrew 6 bolts from the STATOR.
Remove the STATOR.
Note : Hook of connector (1) is on the backside
Pull out the hinge, pressing its snap.
Do not use the pulled-out hinge again. It may be taken
off during operation.
2 3
) , then
)
36
2
Take out any foreign material
from the pump filter (
cleaning, turn the pump filter(
clockwise and insert the
drain plug ( ) to the original
place. close the lower cover cap.
3
). After
)