Front Panel Description - Krell Industries KAV-300IL Instructions For Use Manual

Front Panel Description

See Figure 1 on page 6
POWER
ANALOG
SOURCE
COMPONENTS
Krell KAV–300iL
The front panel of the KAV–300iL accesses power on and off,
analog input selections, volume control, and mute. The front panel
display shows the volume and balance levels, and Theater
Throughput status.
1 Power Button
Use this button to switch the KAV–300iL between the stand-by and
the operational modes.
2 Power LED
The blue power LED illuminates when the KAV–300iL is in the
operational mode. The power LED also flashes when any remote
control key is pressed.
3 Stand-by LED
The red stand-by LED illuminates when the KAV–300iL is plugged
into a standard AC wall receptacle, indicating that the amplifier is
in the stand-by mode and ready to be switched to the operational
mode.
4 Infrared Sensor
The infrared sensor receives commands from the KAV–300iL
remote control. For proper remote control operation, make sure
the infrared sensor is clear of any obstructions.
5 S-1, S-2, S-3, and B-1 Buttons and LEDs
Use these buttons to select a balanced analog source component
(B-1) via an XLR connector or a single-ended analog source com-
ponent (S-1, S-2, or S-3) via single-ended RCA connectors. The
selected button's LED illuminates.
6 Tape Button
Use this button to playback pre-recorded tapes. You may also use
this button to compare the output signal of an analog tape recorder
to an audio source. See Tape Input and Output, on page 17.
7 Tape LED
The red tape monitor LED illuminates when the tape monitor is
activated. The LED does not illuminate when an audio source is
activated.
7