Make Connections And Play; Example Connections; Preparing To Play - Korg ELECTRIBER ER-1 Owner's Manual

Make connections and play!

Example connections

Power switch

Preparing to play

Be sure to turn off the power before making connections. Careless operation may damage your
speaker system or cause malfunctions.
1. Connect the included AC adapter to the DC 9V jack, and plug the adapter into an AC outlet.
As shown in the above diagram, hook the AC adapter cable around the adapter cable holder.
When removing the cable from the holder, do not use excessive force.
2. Connect one end of your audio cables to the line out jacks of the ER-1 (L/MONO, R), and connect
the other end to your mixer or powered monitor speakers (amplified speakers) etc. If you will be
listening in mono, use the L/MONO jack. To take full advantage of the ER-1's sound quality, we
recommend that you listen in stereo.
3. If you will be using headphones, connect them to the headphone jack.
The output from the line out jacks will not be switched off even if headphones are plugged in.
Master volume
4. When you have finished making connections, turn on the power. Slightly raise the master volume
of the ER-1, and strike the part keys (PERCUSSION SYNTHESIZER 1...4) to check whether connec-
tions have been made correctly. Use the master volume of the ER-1 and the gain and fader controls
of your mixer or powered monitor system to adjust the volume to an appropriate level.
Adapter cable holder
AC Local Voltage
1.Introduction
Part keys
7