Turning the power on/off
Connecting the AC adapter
You must use only the included AC adapter.
Using any other AC adapter may cause
malfunctions.
Note: Make sure that the X50's power switch is set
to STANDBY (the outward position).
1. Connect the plug of the included AC adapter to
the power connector on the X50's rear panel.
2. Connect the power cable to the AC adapter.
3. Plug the power cable into an AC outlet.
4. To prevent the plug from being pulled out
accidentally, wrap the AC adapter cable
through the cable hook located on the rear of
the X50. Be careful not to bend the base of the
plug unnecessarily.
Connecting the AC adapter
4 Cable hook
AC adapter
2
Plug into an AC
outlet
3 Power cable
Setup
Turning the power on
1. Lower the X50's [VOLUME] slider.
2. Press the rear panel Power switch to turn on
3. Turn on your powered monitors or stereo amp.
Power switch
4. Raise the X50's [VOLUME] slider to an
1 Power connector
Be careful not to
Note: The state of X50 when the power is turned
bend this portion
on will depend on the setting of "Power On
excessively when you
Mode" (GLOBAL 0: System, Preference page).
wrap the cable
through the cable
(☞p.88)
hook.
If you have connected powered monitor
speakers or a stereo amp, turn down the
volume of these devices.
the power.
The display will show the model name,
software version.
(The following graphic shows the factory-set
display. The version number is subject to
change without notice.)
appropriate position, and adjust the volume of
your powered monitor speakers or stereo amp.
23