Applying An Insert Effect To A Sample And Resampling It - Korg TRITON Extreme TRITON Extreme music workstation/sampler Operation Manual

Applying an insert effect to a sample and
resampling it
The process of applying an insert effect etc. to a sampled
sound and then sampling it once again is called "resam-
pling."
1 In the P0: Recording, Recording page, assign the sam-
ple that you want to resample to "Sample Select."
When the power is first turned on, the assigned sample
will be set to "Orig.Key" C2.
2 Press the page menu button, and choose "Auto Sam-
pling Setup" from the menu.
A dialog box will appear.
3 Choose "Auto Resample through IFX," and select the
effect that you want to use.
4 Press the OK button to execute the command.
Sampling settings will be made automatically.
Let's take a look at the settings that were made auto-
matically.
Input 1 "BUS (IFX/Indiv.) Select": Off
Input 2 "BUS (IFX/Indiv.) Select": Off
Input from the INPUT 1, 2 jacks is turned off.
"Source BUS": L/R
The sound sent to the L/R will be sampled.
"Trigger": Sampling START SW
After you've pressed the SAMPLING [REC] key to
enter sampling-ready mode, resampling will begin
when you press the SAMPLING [START/STOP] key.
"Resample": Auto
The sample assigned to the index will be resampled
automatically.
70
"Key": C2
Use "Key" to specify the sample that will be resam-
pled.
"Recording Level": –12.0
This is the default setting for resampling.
"Save to": RAM
The data will be written to sample memory (RAM).
"Sampling Mode": Stereo
The sound of the internal L/R channels will be sam-
pled in stereo.
"Auto +12dB On": On
The "+12 dB" setting will automatically be turned on
for the samples you record.
"BUS (IFX) Select": IFX1
The output of the sample will be sent to IFX1. (☞step
6)
Be aware that if you change the "BUS" setting from
Off to L/R or IFX1–5, the volume level sent to the
AUDIO OUT L/MONO and R jacks and the head-
phones may rise excessively.
5 In P2: Loop Edit, check the "+12 dB" setting.
By making the following settings, you will be able to
resample at the optimal level.
If "+12 dB" is not checked:
"Recording Level": +0.0 (dB)
(P0: Recording, Recording page)
"Auto +12 dB On": Off (unchecked)
(P0: Recording, Preference page)
If "+12 dB" is checked:
"Recording Level": –12 dB (dB)
(P0: Recording, Recording page)
"Auto +12 dB On": Off (checked)
(P0: Recording, Preference page)
6 In the P8: Insert Effect, Routing page, you can see that
"BUS (IFX) Select" is set to IFX1.