Cautions When Using The Cd-R/Rw Drive; Printing Conventions In This Manual - Korg D3200 Owner's Manual

Cautions when using the CD-R/
• During CD reading and writing operations, keep the unit
in a horizontal position.
• Do not use the unit in extremely cold or hot locations.
• Do not use the unit in extremely humid locations.
• Do not use the unit in dusty or smoky locations.
• Do not subject the unit to vibration or strong physical
shock. In particular, this unit is vulnerable to shock during
CD reading and writing operations.
• Normally, you will be able to open the CD tray by press-
ing the eject button. However if this fails, you can forcibly
eject the tray by inserting a thin object (such as a straight-
ened paper clip) into the emergency eject hole.
• Do not store the unit in hot or humid locations.
• Never touch the focusing lens.
• Do not use commercially available lens cleaners.
• Do not transport the unit with a disc left in the tray.
• Do not leave the unit with the disc tray open.
CD-R/RW handling
Please observe the following points when handling discs.
Failure to observe these points may cause problems such as
data not being written correctly, loss of recorded data, or
drive malfunction.
• Do not leave discs in direct sunlight, or in locations of
high temperature or high humidity.
• Do not touch the surface of a disc. Hold a disc by its
edges.
• Remove dust or dirt from the surface of a disc. To remove
dust, use an air duster or cleaner.
• Do not affix labels to a disc, or write on a disc in locations
other than specified.
• Do not use chemicals or detergent to wipe a disc.
• Do not bend or drop a disc.
Responsibility for loss of data
Korg Corporation will accept no responsibility for any dam-
ages (direct or indirect, whether sustained by the customer or
by a third party) resulting from loss of or damage to data
written on a CD-R or CD-RW disc.
iv
RW drive
Printing conventions in this
manual
Faders, knobs, and keys on the panel
In this manual, "faders," "knobs," and "keys" refer to
controls on the panel. The names shown on the panel are
printed in boldface in the manual.
Examples: MASTER fader, TRIM knob, REC/PLAY key
Items in the LCD screen
"Buttons" and "dialog boxes" are displayed in the LCD
screen. The names shown in the screen are printed in
boldface in the manual.
Items printed in " boldface " are parameters or tab page
names shown in the LCD screen.
Examples: OK button, Rename dialog box, "SetUp" tab
page
Other items printed in boldface
Boldface is also used to indicate the names of non-
selectable parameters shown in the LCD screen, or to
indicate content in the text that we wish to emphasize.
Steps (1) (2) (3) ...
Steps in a procedure are indicated as (1) (2) (3) ...
( → p. ■■ )
This indicates a reference page within this manual.
, ,
These symbols respectively indicate points of caution,
notes of advice, or examples.
..., "XX" tab page
This refers to a page shown in the LCD screen. To access
this page, press the top panel ... key, and then click the
"XX" tab in the LCD screen ( → p.13).
You can also use the panel √ TAB PAGE/TAB PAGE ® keys
to move between tab pages.
..., ..., "XX" tab page
The top panel MIXER key and CD key display a page
jump menu in the LCD screen before the tab pages
appear, so click the page button ( → p.13) and then click
the "XX" tab ( → p.13). Pressing the MIXER key or CD
key will take you back to the page jump menu screen.
LCD screens
The parameter values shown in the LCD screens printed
in this manual are explanatory examples, and may not
necessarily match the displays that appear on your
D3200.