Yamaha Scorpio Service Manual page 173

FRONT BRAKE
5.Install:
Brake pads
G
Brake pads springs
G
***********************************************
Installation steps:
Connect a suitable hose 1 tightly to the
G
brake caliper bleed screw 2. Put the other
end of this hose into an open container.
G
Loosen the brake caliper bleed screw and
using a finger push the caliper pistons into
the brake caliper.
G
Tighten the brake caliper bleed screw.
Brake caliper bleed screw:
6 Nm (0.6 m • kg)
G
Install new brake pad springs and a new
brake pads.
Install the brake caliper 3 and retaining bolts
G
4/brake caliper bolts 5.
Retaining bolt:
27 Nm (2.7m • kg)
Brake caliper bolt:
30 Nm (3.0 m • kg)
***********************************************
6.Inspect:
Brake fluid level
G
Refer to the
INSPECTION" section in CHAPTER 3.
a "LOWER" level line
7.Check:
Brake lever operation
G
Soft or spongy feeling → Bleed the brake
system.
Refer to the "AIR BLEEDING (HYDRAULIC
BRAKE SYSTEM)" section in CHAPTER 3.
6 - 15
CHAS
"BRAKE FLUID LEVEL