Solving Other Problems; Solving Other Problems - Konica Minolta 1800767-001A User Manual

Solving Other Problems

To order KONICA MINOLTA consumables, go to www.q-shop.com.
Symptom
Printer
power is not
on.
Printing
takes too
much time.
Blank pages
come out
during print-
ing.
72
Cause
The power cord is not
correctly plugged into
the outlet.
Something is wrong
with the outlet con-
nected to the printer.
The power switch is
not correctly turned
on (I position).
The printer is con-
nected to an outlet
with a voltage or fre-
quency that does not
match the printer
specifications.
The printer is set to a
slow printing mode
(for example, thick
stock or transpar-
ency).
The printer is set to
power saving mode.
The job is very com-
plex.
A toner cartridge for a
different region or an
unapproved toner
cartridge is installed.
One or more of the
toner cartridges are
defective or empty.
The wrong media is
being used.
Solution
Turn off the printer, confirm that the
power cord is correctly plugged into the
outlet, and then turn on the printer.
Plug another electrical appliance into
the outlet and see whether it operates
properly.
Turn the power switch off (O position),
then turn it back to the on (I position).
Use a power source with the specifica-
tions listed in appendix A, "Technical
Specifications."
It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
It takes time for printing to start in
power saving mode.
Wait. No action needed.
Install a KONICA MINOLTA toner
cartridge approved for your specific
printer.
Check the toner cartridges. The image
will not be printed if the cartridges are
empty.
Check that the media type set in the
driver matches the media loaded in the
printer.

Solving Other Problems