Optical Drive Connector - HP Pavilion 17 Maintenance And Service Manual

3. Lift the battery board (2) to remove it.
Reverse this procedure to install the battery board.

Optical drive connector

NOTE: The optical drive connector and cable are included in the optical drive spare part kit. (See
the Optical drive removal for more information for the spare part kit information.)
Before removing the optical drive connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive.
6. Remove the base enclosure and top cover (see
Remove the optical drive connector board:
Disconnect the cable from the ZIF connector (1), and then disconnect the optical drive connector
▲
(2) from the tabs to remove it.
Battery on page 76).
Base enclosure on page
Component replacement procedures 101
80).