SVMi-4 Installation - Page 29
Immediately after plugging in the SVMi-4 card and turning the system power
switch ON, you MUST press this button to initialise the SVMi-4.
This button should not be pressed if the SVMi-4 is actively processing calls.
Back Plane Connectors These are the connectors to the phone system.
Memory Access LED The Memory Access LED will flash green whenever the
memory is being accessed. This works in a similar way to the hard disk access
LED on a PC.
Run Status LED The Run Status LED shows the operating status of the card.
Green = SVMi-4 running normally, Any other condition indicates a fault.
Port Status LED Each LED (1 – 4) will indicate that a call is in progress on
that port.
Memory This device is a Compact Flash media card used for storing the main
system program and all messages and prompts. The amount of storage is mea-
sured in Megabytes (MB). To remove or insert a memory card, first remove the
SVMi-4 card from the system and then pull out or insert the Compact Flash.