Appendix; Specifi Cations - Sharp Aquos LC-60LE660X Operation Manual

Appendix

Troubleshooting
The problems described below are not always caused by malfunctions. Check the TV again before having the
TV serviced.
Problem
• No power. • Check if you pressed POWER on the remote control unit. (See page 6.)
If the indicator on the TV lights up red, press POWER.
• Is the AC cord disconnected?
• Has the power been turned on? (See page 6.)
• Unit cannot be operated. • External infl uences such as lightning, static electricity, etc., may cause improper operation.
In this case, operate the unit after fi rst turning the power off the TV or unplugging the AC
cord and re-plugging it in after 1 or 2 minutes.
• Is battery inserted with polarity (e, f) aligned? (See page 4.)
• Remote control unit does
not operate.
• Is battery worn out? (Replace with new battery.)
• Are you using it under strong or fl uorescent lighting?
• Is a fl uorescent light shining on the remote control sensor?
• Picture is cut off. • Is the image position correct? (See page 11 and 12.)
• Are screen mode adjustments such as picture size made correctly?
(See pages 7 and 11.)
• Strange colour, light • Adjust the picture tone. (See page 7.)
colour, or dark, or colour
• Is the room too bright? The picture may look dark in a room that is too bright.
misalignment.
• Check the colour system setting. (See pages 6 and 11.)
• Check the input signal setting. (See page 11.)
• Check the HDMI auto view setting. (See page 8.)
• Power is suddenly turned • The unit's internal temperature has increased.
off.
Remove any objects blocking the vent or clean.
• Check the ECO setting. (See page 8.)
• Is the sleep timer set? (See page 4.)
• No picture. • Is the connection to external equipment correct? (See page 3.)
• Has the input signal setup been performed correctly after connection? (See page 11.)
• Is the correct input selected?
• Is the "Picture adjust" correct? (See page 7.)
• Is the antenna connected properly? (See page 3.)
• Is "On" selected in "Audio only"? (See page 11.)
• No sound. • Is the volume too low? (See page 4.)
• Make sure that headphones are not connected.
• The TV sometimes makes a • This is not a malfunction. This happens when the cabinet slightly expands and contracts
cracking sound. according to changes in temperature. This does not affect the TV's performance.
Cautions regarding use in high and low temperature environments
• When the unit is used in a low temperature space (e.g. room, offi ce), the picture may leave trails or appear slightly delayed.
This is not a malfunction, and the unit will recover when the temperature returns to normal.
• Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight or near a
heater, as this may cause the cabinet to deform and the LCD panel to malfunction.
Storage temperature: f20°C to e60°C.
Possible Solution
Specifi cations
Item Model
LCD panel
Resolution
Video colour system
TV function TV-standard Analogue
Digital
Receiving VHF/UHF
channel
CATV
TV-tuning system
STEREO/BILINGUAL
Viewing angles
Audio amplifi er/Speakers
Terminals Antenna input
INPUT 1 (HDMI/ARC)
INPUT 2 (HDMI/MHL)
INPUT 3/INPUT 4/INPUT 5 (HDMI)
INPUT 6
INPUT 7
INPUT 8 (PC)
AUDIO OUT
AUDIO IN (HDMI 5/INPUT 8 (PC))
USB 1/USB 2
OUTPUT
RS-232C
DIGITAL AUDIO OUTPUT
Headphone
C.I. (Common Interface)
ETHERNET (10/100 BASE-T)
OSD language
Power requirement
Power consumption
Dimensions without stand
with stand
Weight without stand (with stand)
Operating temperature
1
* The HDMI 5 and INPUT 8 terminals can both use the same audio input terminal.
• As a part of policy of continuous improvement, SHARP reserves the right to make design and specifi cation changes for
product improvement without prior notice. The performance specifi cation fi gures indicated are nominal values of production
units. There may be some deviations from these values in individual units.
• Specifi cation may differ depending on the selected country.
CAUTION
• Installing the Liquid Crystal Television requires special skill that should only be performed by qualifi ed service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting
that results in accident or injury.
• Carefully read the instructions that come with the bracket before beginning work.
LC-60LE660X LC-70LE660X
152 cm 177 cm
2,073,600 pixels (1920 g 1080)
PAL/SECAM/NTSC 3.58/NTSC 4.43/PAL 60
PAL: B/G, D/K, I SECAM: B/G, D/K, K/K NTSC: M
1
DVB-T2
44.25—863.25 MHz
S1—S41 ch (including Hyperband)
Auto Preset 99 ch
NICAM: B/G, I, D/K A2 stereo: B/G MTS: M
H: 176º V: 176º
10 W g 2 / 4.5 g 10 cm 2pcs
UHF/VHF 75 q DIN type
HDMI (HDMI input)
HDMI (HDMI input)
HDMI (HDMI input)
VIDEO in, AUDIO in, COMPONENT in
VIDEO in, AUDIO in
15 pin mini D-sub
AUDIO out
1
3.5 mm jack*
USB
USB
9 pin D-sub male connector
Optical Digital Audio Output
3.5 mm stereo
EN50221, R206001, CI Plus specifi cation
Network connector
English/Simplifi ed Chinese/Arabic/French/Portuguese/Russian/Persian/
Thai/Vietnamese/Indonesia
AC 110 — 240 V, 50/60 Hz
175 W (0.5 W Standby) 209 W (0.5 W Standby)
1,355 (W) g 817 (H) g 86 (D) mm 1,563 (W) g 934 (H) g 87 (D) mm
1,355 (W) g 835 (H) g 350 (D) mm 1,563 (W) g 952 (H) g 350 (D) mm
24 kg (27 kg) 34 kg (37 kg)
0°C — 40°C
- 17