Table of Contents
Advertisement
Troubleshooting Guide
If you use this for the first time, it may be
difficult to receive signals in the beginning.
In such a case, leave the SIRIUS source ON
for 3 minutes and turn it OFF and ON.
What might appear to be a malfunction in
your unit may just be the result of slight
misoperation or miswiring. Before calling
service, first check the following table for
possible problems.
?
The SIRIUS mode cannot be selected.
✔ The SIRIUS connection wire is not connected.
☞ Use the SIRIUS connection wire to connect the
control unit and the SIRIUS satellite radio tuner.
✔ The changer switching unit "KCA-S220A" is not
connected properly.
☞ Connect the KCA-SR50 to the terminal labelled
TO CHANGER 2. See the section on <Connecting
Wires to Terminals>.
?
Nothing happens when the buttons are pressed.
✔ The computer chip in the unit is not functioning
normally.
☞ Press the reset button on the Control unit.
?
No broadcast can be received.
✔ No subscription is established.
☞ Subscribe to SIRIUS.
10
|
English
The following messages are displayed
when certain problems are occurring
in your system. Take the recommended
actions.
ANTENNA ERROR / ANT ERR / ANT ERROR :
Antenna is not connected correctly.
➪ Make sure the antenna is connected
correctly and then turn OFF/ON of the
SIRIUS source or Control unit.
TUNER ERROR / TUNE ERR :
Broadcast cannot be received due to an error
in this unit.
➪ Turn OFF/ON of the SIRIUS source or
Control unit, or press the reset button of
Control unit.
ESN ERROR / ESN ERR :
ESN (Electronic Serial Number) is not
registered in this unit.
➪ Consult your nearest service center.
CHECK SIRIUS / CHK SSR :
The SIRIUS tuner is disconnected or a unit
other than the SIRIUS tuner is connected.
➪ Check the connection to the SIRIUS tuner.
Advertisement
Table of Contents
