Rechargeable Battery - Sony Handycam DCR-DVD92E Operating Manual

On the pickup lens
• Do not touch the lens inside the disc cover.
Keep the disc cover closed except when
inserting and removing the disc, to keep dust
out.
• When the camcorder does not work because the
pickup lens is dirty, clean it with a blower (not
supplied). Do not touch the pickup lens directly
during cleaning because this may cause the
camcorder to malfunction.
pickup lens
Care and storage of the camera lens
Wipe the surface of the lens clean with a soft
•
cloth in the following instances:
– when there are fingerprints on the lens
surface.
– in hot or humid locations
– when the lens is exposed to salty air such as
at the seaside.
Store the lens in a well-ventilated location
•
subject to little dirt or dust.
To prevent mold, periodically clean the lens as
•
described above. It is recommended that you
operate your camcorder about once a month to
keep it in optimum state for a long time.
To charge the pre-installed

rechargeable battery

Your camcorder has a pre-installed
rechargeable battery to retain the date,
time, and other settings even when the
POWER switch is set to OFF (CHG).
The pre-installed rechargeable battery
is always charged while you are using
your camcorder but it will get discharged
gradually if you do not use your camcorder.
The rechargeable battery will be fully
discharged in about 3 months if you do
not use your camcorder at all. However,
even if the pre-installed rechargeable
battery is not charged, the camcorder
operation will not be affected as long as
you are not recording the date.

Procedures
Connect your camcorder to a wall socket
using the AC adaptor supplied with your
camcorder, and leave your camcorder with
the POWER switch turned off for more
than 24 hours.
To change the battery of the Remote
Commander (Except for DCR-DVD92E/
DVD602E)
 While pressing on the tab, inset your
fingernail into the slit to pull out the
battery case.
 Place a new battery with the + side facing
up.
 Insert the battery case back into the
Remote Commander until it clicks.
Tab
111