Black & Decker PRFM1500 Manual page 8

ENGLISH
Use
Switching on and off
•
When connected to an electrical supply, the
indicator (11) will flash red.
•
The appliance will operate when the power
button (4) is pressed once. The indicator will
change to a solid blue colour.
•
Pressing the power button again will stop the
appliance.
•
The direction of feed screw rotation can be
reversed by pressing the reverse button (5).
Rotation can be paused by pressing the
reverse button. Releasing the reversing
button will allow the mincer to continue as
normal.
Note: the cover must be raised to assess the
reverse button.
Making Mince
•
After assembling the unit, place the mincer
on a flat dry surface, ensuring that the
ventilation openings are not blocked.
•
Connect the appliance to a suitable electrical
supply.
•
Place a bowl or container below the locking
nut (9) to collect the minced meat.
•
Ensure that the meat is thawed thoroughly
before mincing. Check the meat for bones
and unwanted fat. Clean the meat and cut
into small cubes to fit the filling shaft and
drop them into the food tray.
•
Press the power button (4) to start the
appliance.
•
Slowly feed the meat pieces into the grinder
from the food tray and push down with the
food pusher (12). Do not apply excessive
force as this could damage your unit.
8
Note: Never use finger to guide the ingredients
– always use the pusher.
•
If the machine stalls or jams during use,
switch off by pressing the power button (4).
Press the reverse button (5) for a few
seconds to release the obstruction. The lamp
will change to a solid red to indicate the feed
screw is operating in reverse. Disconnect the
appliance from the electrical supply, and
remove any unwanted material from the
grinder.
Note: In order to protect the appliance, this
product has an auto-off function. After running
constantly for 6 minutes the product will stop
working and the indicator (11) will flash red. The
unit can be re-started by pressing the power
button (4) again.
Note: After 2 continuous uses of 6 minutes, the
lamp will flash red twice. Allow the appliance to
cool to room temperature before using it again.
The indicator (11) will return to single red flash
indicating the unit is ready for use.
Once mincing is completed, press the power
button (4) to turn the unit off and remove the
plug from the electrical supply before
disassembling and cleaning the unit.
Note: The unit is fitted with a thermal-cut-out.
The product will stop working and the lamp will
flash twice. If this should happen, allow the
appliance to cool to room temperature. The lamp
will flash red to indicate readiness for use.
Tool Storage (Fig F)
•
Use the tool storage compartment (3) on the
base unit to store the accessories.
•
The tool storage is opened by pressing the
tool storage release (20) and pulling the tray
from the motor housing (1).