Konica Minolta bizhub C450 Fax Manual page 386

13
Terms
S
T
U
V
Z
13-10
Description
Sender information Information such as transmission date, name, telephone
number, and page number printed at the top of the re-
ceived document at the fax transmission.
Sender name The name of this machine, which is represented with any
alphanumeric character and symbols. It is recorded as the
part of the originating printing at the top of the received
document on the receiver side.
Substitute transmit The function to transfer/transmit the received documents
waiting for output by using the control panel. Substitute
transmission can be set when the fax screen is displayed,
and operation has been interrupted at out of paper or pa-
per jammed in the machine.
Super G3 (SG3) This is the G3 communication mode that is ITU-T V.34
compliant. It can communicate faster (up to 33,400 bps)
than normal G3 communication.
Timer TX The function to specify the time to start communication.
You can save costs by specifying a transmission to start
at midnight or early in the morning during which telephone
charges are less.
Total page set The function to place the total number of pages on each
page of the fax in quick memory transmission. It is useful
for the recipient to make sure whether all pages of the fax
have been sent or not (the total number of pages are au-
tomatically placed in memory transmission).
Transmission rates The transmission rates of the modem in the facsimile. It
can transmit in high-speed 33,600 bps. If it is set to Over-
seas TX. The international communication. In Overseas
TX, a lower baud rate will be employed. Select this mode
if you send a fax to the location at which the communica-
tion condition is poor even if it is in your country. It trans-
mits in noise-resistant 7,200 bps or 4,800 bps.
Transmission time The time to send a fax. The higher resolution is, the longer
it takes to transmit.
Upside down The function to specify the appropriate binding style when
transmitting a two-sided document (i.e., when pages are
printed on both sides). The binding style you select should
allow the pages of a two-sided document to be read ap-
propriately by paging right to left or top to bottom.
V.34 The communication mode under the super G3 fax com-
munication. It may not be possible to communicate in su-
per G3 mode if the receiver or sender is connected to the
line via an extension exchange equipment.
Vertical scanning The vertical direction when the original is scanned.
Z folded original The function to determine the document sizes before
reading and sending the original. Some facsimiles cannot
detect the document size if it has been folded. This func-
tion is available only when reading the original with the
ADF.
Appendix
C450