Current Draw And Thermal Dissipation Specifications - Lab.gruppen PLM Series Operation Manual

9.3.2 Input and Router Defaults
Autoselect: On
Input sensitivity: +26 dBu
Dante: Disabled
AES3: Terminated
Iso-Float: Enabled
Router 1: Priority 1 = Dante Receiver (Ch.1)
Priority 2 = Empty
Priority 3 = AES1 (Ch.1)
Priority 4 = Analog 1
Router 2: Priority 1 = Dante Receiver (Ch.2)
Priority 2 = Empty
Priority 3 = AES1 (Ch.2)
Priority 4 = Analog 2
9.3.3 Amplifier and Device Defaults
Attenuation:
Polarity:
Mutes:
Load Model:
Breaker Emulation Limiter:
IP Configuration:
Dual Redundancy:
Dante Slave Only:
9.4

Current Draw and Thermal Dissipation Specifications

The tables in this section provide measured current consumption and calculated heat dissipation for five
different operating conditions for each PLM Series device.
1. Standby Mode
2. Power On (Idle - No Signal)
3. Power On (Normal Operation - Pink Noise 1/8 of Rated Power)
4. Power On (Heavy Duty Operation - Pink Noise Max Power) - Not available for PLM 20000Q
5. Power On (Pilot Tone Operation - 20 kHz Sine Wave)
0 dB
Positive (In phase)
Unmuted
No Load Model
32 A - Breaker Fast (PLM 20000Q only)
Auto Zero Conf. (Auto IP)
Disabled
Enabled
PLM Series Operation Manual Rev 1.3.5
Appendix
79