Service Devices; Product Specific Devices; Rework Jigs And Stencils - Nokia RM-598 Service Manual

RM-598; RM-604
Service Devices and Service Concepts

Service devices

Product specific devices

The table below gives a short overview of service devices that can be used for testing, error analysis, and
repair of product RM-598; RM-604. For the correct use of the service devices, and the best effort of workbench
setup, please refer to various concepts.

Rework jigs and stencils

The table below gives a short overview of service devices that can be used for testing, error analysis, and
repair of product RM-598; RM-604. For the correct use of the service devices, and the best effort of workbench
setup, please refer to various concepts.
Issue 1
FS-120
• FS-120 is equipped with a clip interlock system
• provides standardised interface towards Control Unit
• multiplexing between USB and FBUS media, controlled by VUSB
MJ-239
MJ-239 is meant for component level troubleshooting.
The jig includes an RF interface for GSM and WCDMA. In addition, it has
the following features:
• Provides mechanical interface with the engine module
• Provides galvanic connection to all needed test pads in module
• Multiplexing between USB and FBUS media, controlled by Vusb
• MMC interface
• Duplicated SIM connector
• Connector for control unit
• Access for AV- and USB connectors
RJ-230
RJ-230 is a soldering jig used for soldering and as a rework jig for the
engine module.
COMPANY CONFIDENTIAL
Copyright © 2009 Nokia. All rights reserved.
Flash adapter
Module jig
Soldering jig
Page 2 –5