JVC FS-P550 Service Manual page 18

3.1.15 Removing the switch board
(See Figs.25 and 26)
• Prior to performing the following procedures, remove the side
panels L/R and front panel assembly.
(1) From the front side of the front panel assembly, pull out the
volume knob in to the direction of the arrow. (See Fig.25.)
(2) From the inside of the front panel assembly, remove the
ten screws U attaching the switch board. (See Fig.26.)
(3) Take out the switch board from the front panel assembly
and disconnect the card wire from the connector
the switch board. (See Fig.26.)
Reference:
When attaching the switch board, align the projections p of the
front panel assembly in the holes of the switch board. (See
Fig.26.)
1-18 (No.MB229)
CN760 on
Card wire
U
Switch board
Front panel assembly
Volume knob
Fig.25
CN760
p
Fig.26
U
p
U