1. Removing transport safety bolts at the rear of the machine
C
The transport safety bolts must be
removed before any operation of the
machine. Bolt heads, marked "C".
Remove transport safety bolts and rubber
bushes by pulling outwards. (An up/down
action and a small squirt of washing up
liquid should ease removal.)
2. To open the door,
make sure the on/off switch is in
the off position, always allow one
to two minutes for the door
3. Water connections
a) Water inlet hoses
Your machine
comes with only cold
water connection. Find the blue
hose supplied by the
manufacturer for water
connection. Connect the
cold water using the
blue hose.
4. Stability
Feet adjustment
GB
C
"C", should be turned in an anti
clockwise direction until the bolt
can be partially withdrawn.
safety lock to release the lock.
Press the door knob the door will
spring open.
For proper operation,
the pressure of water should be
between 1 and 10 atm. (1 atm
corresponds to more than 8 liters per
minute flow rate at fully open tap.)
To prevent water
leaks two rings are supplied
with the water inlet hose inside the
machine, Place these rings on
each side of the hose and tighten
both ends fully.
In order to
prevent any water leak damages,
keep the water taps closed when
not in use. Connect the cornered
end of the hose to the machine
water inlet.
Washing Machine is to be connected to the
water mains using new hose-sets and that
old hose-sets should not to be reused.
To ensure quiet and stable operation, the machine should be
positioned correctly and levelled on its feet. Your machine
comes with two adjustable feet. If the machine is unstable,
loosen the plastic lock nut and screw or unscrew the
adjustable foot until the machine is levelled perfectly. After
positioning, tighten the lock nut for stability. Ensure a
clearance is present each side of the machine to allow slight
side ways movement during washing and spin drying
operations.
Plastic plugs, supplied inside the protective bag and
P
designated as "P", should be placed in the safety bolt
holes according to the direction shown.
Attention! Please keep the safety bolts for
future transportation
and reinstate them before transporting your
machine. Never transport your machine
without the transport bolts in position. Any
resultant damage is not covered by the
warranty.
Attention!
on a carpet. This prevents air circulation.
The electrical components of the machine may
overheat and may cause damage.
b) Drain hose
The drain hose should be placed and secured
either at the side of the hand basin or directly
to the drain. The hose should not be bent.
The waste pipe must only
be connected into the
foul drains not surface
water drainage system.
Never place your machine
The hose should
be placed between
60 and 100 cm.
from the ground.
And must not be extended
otherwise the machine
may not empty the waste
water.
60-100 cm