Starting Up The Device; Boiling Water - Silvercrest SWKT 3000 A1 Operating Instructions Manual

• Do not allow individuals (including children) to
use the appliance whose physical, sensorial or
mental abilities or lack of experience and know-
ledge hinder their safe usage of it if they have
not previously been supervised or instructed in its
correct usage.
• Tell children about the appliance and its potenti-
al dangers so that they do not play with it.

Starting Up the Device

• Before starting up the device, make certain that...
– the device, plug and power cable are in good
working order and...
– all packaging materials have been removed
from the device.
• Fill the device with water up to the MAX mark
and let it come to a full boil once as described in
the next section. Pour out this water.

Boiling Water

Danger! Never place the electrical base
near water – life-threatening danger!
Warning: Pull the power plug from the
socket before lifting the kettle
base . This prevents any water
t
splashing out from contacting the electrical
connections in the base
cause a short circuit.
For safety reasons, the lid
be opened while the water is boiling or is
very hot. Otherwise there is a risk of
injury.
You should only heat as much water as you need
directly. That helps you save electricity, water and
time:
from the
u
, which could
t
q should not
- 3 -
• Lift away the kettle
• Open the lid by pressing down on the unlok-
q
king button .
w
• Hold the kettle u vertically while filling. Only
then will the level indicator
correctly indicate the water volume.
Fill the kettle ...
u
– at least to the MIN mark so that the device does
not overheat,
– no higher than the MAX mark so that no boiling
water spills out.
• First close the lid q
• then place the kettle
straight on the base
• Set the desired water temperature using the
temperature control
To bring the water to a boil, you must set the
temperature controller
• Now insert the power plug into the power
socket and press the ON/OFF switch
until it snaps in.
• The operating light
now heating up.
MIN
Temperature regulator in the boiling range
• The devices switches off automatically and the
operating light goes out as soon as the water
r
is at a full boil. The ON/OFF switch
out.
for filling!
u
on the side
i
...
on the base until it sits
u t
.
t
y .
to the MAX position.
y
e down
indicates that the device is
r
Transition-
range
MAX
springs
e