Table of Contents
Advertisement
KF-50SX100/50SX100K/50SX100U
RM-903
(2) 60Hz adjustment
* Input NTSC MONOSCO. Adjust "3. SYRDLY" to find out
the value terrible picture flicker occures.
Note the value for 60Hz adjustment.
1) Receive RF and change picture to INDEX
2) Adjust V center by "3. SYRDLY".
Be sure that ± 1 step area of the noted value is prohibited.
RM-903
RM-903
3-8. TEST-TEST MODE
1.1.3 Test-Test-Commands
Entering the TT mode method :
Commander : Press test button twice.
The diagnosis menu can be displayed by these methods :
TT mode :
Service Menu :Monitoring t Error Monitor or LCD-
Engine Error Menu
For correction of any wrong input (first digit.) by mistake these
methods are possible :
Press"- -"
Press"0"
Press test button
The test-Test Mode can be left by these methods :
Press"0" twice.
Press TV button
Press standby button
00
TT mode off
01
picture maximum
02
picture minimum
03
volume = 30% (speaker and headphone)
04
volume = 50% (speaker and headphone)
05
volume = 65% (speaker and headphone)
06
volume = 80% (speaker and headphone)
07
Ageing Mode
This TT mode is stored in NVM, after power shut down TV
starts again in Ageing mode. Ageing Mode can be left by
pressing TV button.
Volume is set to minimum.
08
Shipping Conditions
Note : The u-controller checks all possible IC's and
generate an internal list.
This list is the base of the error check procedure.
Production mode = off
Ignore Errors = off
Errors = cancelled
Standby = off
Parental lock = off
Ageing white = off
Flash = erased
Language = English
Country = off
AV1 = Normal, "AV1"
AV2 = Normal, "AV2"
AV3 = Normal, "AV3"
AV4 = Normal, "AV4"
AV In Main = AV1
AV In Sub = AV1
AV2 Out = TV
Main program = 1
Sub program = 2
– 44 –
Press 33
Advertisement
Table of Contents
