Advertisement
Quick Links
Advertisement
Related Manuals for Aquacal AUTOPILOT 110
Summary of Contents for Aquacal AUTOPILOT 110
-
Page 1: Heat Pump
Heat Pump Quick Start Guide Models: 035, 055, 075,115, 110, 120, 121, 155, 156, & 175 For product manuals and further installation / operation procedures visit www.AquaCal.com Important Read This Guide Before Installing or Operating Heat Pump LTP0074 Rev 2 12/27/2011... -
Page 2: Section 1 - General Information Contacting Aquacal Autopilot
Phone 8:00 a.m. to 5:00 p.m. Eastern time, Monday through Friday (727) 821-7471 Please have your model and serial numbers available when contacting AquaCal AutoPilot for questions, service, or parts. SAFETY For personal safety, and to avoid damage to equipment, follow all safety instructions displayed in this guide. Repair and service of your heat pump must be performed by qualified service personnel. -
Page 3: Section 2 - Installation
SECTION 2 - INSTALLATION For commercial or complete installation instructions please, visit www.AquaCal.com for equipment manual. EQUIPMENT CLEARANCES Keep the area immediately adjacent to the heat pump clear of items such as shrubs and bushes, lawn furniture, chemicals containers, etc. These items can prevent air from circulating properly through the heater, and will result in inefficient operation and/or damage to the heat pump. -
Page 4: Section 3 - Operation
“MODE” to temporarily unlock Heat Pump. If code is unknown, a re- set option is available in product manual. Manuals can be downloaded from www.AquaCal.com. When this mode is active, the heat pump will automatically switch between heating and cooling modes to maintain a set temperature point within Heat Pump is set to cool the water. -
Page 5: Section 4 - Maintenance
PROGRAMMING Activity Step 1: Select the “POOL / SPA” button to choose the thermostat to adjust. Step 2: Select the “UP” or “DOWN” button to increase or decrease the desired set temperature. Adjusting Step 3: Once set, the current water temperature will be displayed. The Heat Pump will start to operate to meet Temperature the desired temperature. -
Page 6: Section 5 - Troubleshooting
Refrigerant Issue “LP5” Error Refrigerant Issue “OTA” Over Temperature Alarm Other heating equipment Temperature over 110° F (Unit Locked) “PC” Error Water Temperature Sensor Shorted “PO” Error Water Temperature Sensor Open RESOLUTION Step 1: Confirm water pump is on and water valves are in the correct position to allow water to flow through Heat Pump.