You can perform one of the following operations by tapping the screen once while measuring.
Tapping is only supported by SF-710/SF-510.
❏ When you want to change functions operated by tapping, set Tap from the Measure set. menu.
"Measure set." on page 106
❏ The operation may not be recognised if you tap the screen rapidly in succession. Leave a gap of approximately one
second between taps.
❏ When bike mode is selected, the tap function may operate automatically depending on the condition of the road surface.
If this occurs, we recommend to change the setting to OFF.
This function allows you to sound an alarm when pausing a lap, setting the target pace, and so on.
The following shows the alarm timing. A long alarm sounds when the lap is paused, and a short alarm sounds at other
Also, vibration is only supported by the SF-710.
Preparing and Basic Operations
Records the lap.
The same operation as pressing D while measuring.
Turns on the light. The light turns on for approximately 10 seconds.
The same operation as pressing B.
Changes between the four measurement screens.
The same operation as pressing A.
Turns off tap operations.