Epson Runsense SF-710 User Manual page 137

SF-710/510/310 User Manual
Heart Rate Monitor
Communication
Web application
If you cannot solve the problem even after trying the points above, contact our service centre.
Troubleshooting
Problem
The heart rate monitor is not
working correctly.
The device is not recognised
correctly when it is connected
to a computer.
When communicating with a
computer, an error screen is
displayed and
communication stops.
Check the following items.
❏ Are you wearing the HR belt correctly?
"Wearing the heart rate monitor" on
U
page 67
❏ Has it been registered to the device?
"Registering the heart rate monitor to the
U
device" on page 68
❏ Is the heart rate monitor set to ON.
"Enabling the heart rate monitor" on
U
page 70
❏ If you cannot register to the device, replace
the battery after resetting the heart rate
monitor. To reset the heart rate monitor, place
the battery in the battery compartment so
that the negative side is facing up, and leave it
for three seconds.
❏ Is the battery running out? Replace the battery
if it is running out.
"Replacing the Battery for the Heart Rate
U
Monitor" on page 74
❏ Perform a system reset for the device.
"Resetting the System" on page 138
U
Check the connection for the computer and the
cradle. Clean the contact points on the device and
the cradle.
"Looking after your device" on page 130
U
Perform a system reset.
"Resetting the System" on page 138
U
Do not move the device and the cradle during
communication. Avoid communicating data
under environments where static electricity can
be easily generated. If the same error occurs,
reconnect the cradle to start the communication
again.
137
Solution