Software upgrade & Procedure to restore product setting
1)Restore factory setting
a) Press <SETUP> button on R/C
b) Select <preference setup> ,then press < OK >
c) Select <default>,then press <OK> to confi rm
2)Stroke version setting
a) Open the Door,then,press "1" "5" "9" on RC
b) Press <OK> button on RC
c) TV will show message as follow:
Current model:
5540-93
Version:00.08.00_0
Release:2009.12.22
Region:2
Servo:AE.57.F1.00
8032: 05.00.04.06
Risc: AA.00.00.00
MCU: 07.00
Touch: 0009
TX:
Error
RX:
Error
if current model does not match you set,
use down arrow key on the remote to change
OK
3)Password change
a) Press <SETUP> button on R/C
b) Select <preference setup> ,then press <OK>
c) Select <password> <change>,then press <OK> to confi rm
"0000" is default password supplied.
4)Trade model
a) Press <Open/Close>button on R/C
b) Press "2" "5" "9" on R/C,VFD will display "TRA ON " or "TRA
OFF"
5)Check on software version
a) Press <SETUP> button on R/C
b) Select <preference setup> ,then press <OK>
c) Select <version info>,then press <OK>
d) TV will show message as follow:
Preference setup
Version Info.
Current model:
5540-93
Version :00.08.00_0
Release: 2009.12.22
Region: 2
Servo: AE .57.F1.00
8032:05.00.04.06
Resc:
AA.00.00.00
MCU: 07.00
Touch: 0009
TX:
Error
RX:
Error
OK
Press SETUP to exit menu
2 - 1
a) Copy the latest upgrading software onto a CD-R or USB storage
device
b) Insert the CD-R program disc or connect the USB storage device
to the home theater
c) TV will show message as follow
Upgrade fi le detected
Do you wish to continue with
the software upgrade?
OK
Cancel
d) Select <OK>,the home theater will start to upgrading
automatically
Note: when upgrade in progress, please do not unplug or switch off
the device.
when the updated is complete ,the home theater automatically
switch to standby.
7) Produce to change Tuner grid
Only applicable for certain regions, in some countries, the
frequency step between adjancent channels in the FM hand is
50KHZ(100KHZ in some areas)
a) Press<radio> on R/C to select "FM"
b) In "FM" playbak mode,press & hold< play/pause> button until
"grid 9" or "grid 10" appears
Note: repeaing the same action will toggle back to it previous
tunning grid setting.
* "grid 10" is default for /93/94/51 version.
8) How to replace the defective DVD loader module
a) Remove the defective DVD loader module.
b) Connect DVD loader to "CN801", "CN802", "CN803" on the top of
main board as shown below.
CN801
CN803
CN802
c) Remove solder joint on the ESD protection points.
The ESD protection points on
the top of DVD loader board
Note: if the DVD loader is ok, must solder the ESD protection points
on the top of DVD loader board before remove the connect "CN801"
"CN802" "CN803" on the top of main board cable, lest should
damage the DVD loader.
CAUTION!
This information is confi dential and may not be
distributed.Only a qualifi ed service person should
reprogram the Region Code.
2 - 1
Str
Str
Str
Str
So
So
So