Check Operation; If Dishwasher Does Not Operate; Additional Tips - KitchenAid KDTE334DSS Installation Instructions Manual

Undercounter dishwasher stainless steel tub
Table of Contents

Advertisement

Available languages

Available languages

Tighten access panel screws.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Plug into a grounded 3 prong outlet.
24
Reconnect Power

Check Operation

Read the Dishwasher User Guide that came with your
dishwasher.
Check that all parts have been installed and no steps were
skipped. Check that you have all tools used.
Start dishwasher and allow it to complete the shortest wash
cycle. After the first 2 minutes, unlatch door, wait 5 seconds,
then open door. Check that there is water in the bottom of the
dishwasher tub. Check that dishwasher is working properly.
If the dishwasher is not working properly, disconnect power or
unplug dishwasher and See the "If Dishwasher Does Not
Operate" section.

If Dishwasher Does Not Operate

First try the solutions suggested here to possibly avoid the cost of
a service call.
Has the circuit breaker tripped or the house fuse blown?
Is the door closed tightly and latched?
Has the cycle been set correctly to start the dishwasher?
Is the water turned on?
If none of these possible solutions work, please see the User
Guide for service contact information.

Additional Tips

Expect longer wash times. Your new dishwasher will average
2 to 3 hours per load, but use nearly 40% less energy than older
models. Designed with a low wattage, low energy consumption
motor, your dishwasher washes longer to ensure exceptional
cleaning. Certain models are equipped with an optical water
sensor so the first cycle will run longer to calibrate to optical
sensor. Selecting certain options could increase cycle time past
3.5 hours.
Rinse aid is necessary for good drying results:
This dishwasher is designed to be used with rinse aid for good
drying performance and controlling hard water deposit buildup.
Energy efficient dishwashers use less water and energy, so they
depend on the water sheeting action of rinse aid for good drying
performance.
Start/Resume indicator light may flash:
When pressing Start/Resume, you must make sure the door is
closed within 3 seconds. If you do not close the door within
3 seconds, the Start/Resume indicator light will flash until you
press it again. (You must also do this when adding a dish during
the middle of a cycle.)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents