The Following Fault Messages Appear In The Display At The End Of The Programme - Miele WKR 770 WPS Operating Instructions Manual

Problem solving guide
The following fault messages appear in the display at the end of
the programme
Problem

Intensive flow: Clean
the filter and jets or
remove foreign ob-
jects from the pump
housing.

Align the washing
machine
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor.
76
Cause and remedy
The pumps are dirty.
 Clean the pumps as described in "Problem solving
guide - Opening the door in the event of a blocked
drain outlet and/or power failure"
 Start the programme again after cleaning the
pumps.
The jet in the top of the door ring is blocked with fluff.
 Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
 Start the programme again after cleaning the jet.
If the fault message appears again, contact the Serv‐
ice Department. The washing machine can still be
used but with reduced functionality.
The smoothing process which the laundry undergoes
at the end of the programme could not be carried out
properly.
 Check whether the washing machine is aligned
correctly as described in "Installation and connec‐
tion - Levelling the machine".
 Check whether the maximum delivery height of 1
m has been exceeded.
If the fault message appears again, contact the Serv‐
ice Department. The washing machine can still be
used but with reduced functionality.