Changing The Projection Lamp - Kodak Slide Projector Operating Manual

Changing the Projection Lamp

KODAK CAROUSEL® Slide Projector
Slide the power switch to Off and unplug the projector.
Allow the projector and lamp
to cool for about 10 minutes.
Push the lamp-module
release button and remove
the lamp module.
Note: There is an additional
safety latch, which reduces
the chance of an accident
with a loosely inserted lamp
module, that may cause some
resistance. To release the
latch, you may need to apply
extra effort when you pull out
the module.
Lift up the lamp release clip. Carefully remove the worn lamp from the
socket and place it on a heat-resistant surface.
Insert a new lamp into the
socket. Push down to tightly
seat the replacement lamp.
Relatch the clip in the forward
position and push the lamp
module all the way back into
the projector until it latches.
Maintenance
21