Preference > Audio Setting - Sanyo HVR-DX625H Instruction Manual

Preference > Audio Setting
Follow the same procedure as 'Video' Settings to
select 'Audio' Settings.
Preference
ENTER
Digital Output
1 Use [ENTER] to select 'Digital Output' while the
'Audio' submenu is displayed.
2 Press [ENTER] or [√] to go to the second level.
Use [... †] to select the desired digital output
3
type.
Preference > Audio
ENTER
4 Press [ENTER] to confirm your selection.
5 Press [SETUP] to exit the menu.
Bitstream
Select when connected to a Dolby Digital or DTS
decoder (or an amplifier or other equipment with a
Dolby Digital or DTS decoder).
PCM
Select when connected to a 2 channel digital stereo
amplifier. The DVD Recorder + VCR's digital audio
signal will be output in the PCM 2ch format when you
play a DVD recorded with a Dolby Digital (only for
DVD) or MPEG soundtrack. If the DVD is recorded
with a DTS sound track then no sound will be heard.
Video
Audio
†
Parental Control
Change Password
Auto Setting
VCR
Confirm Back Exit
MENU SETUP
Digital Output Bitstream
†
Dynamic √ PCM
Confirm Back Exit
MENU SETUP
Dynamic Range
While watching DVD movies, you may wish to
compress the dynamic range of the audio output (the
difference between the loudest and quietest
passages). This allows you to listen to a movie at a
lower volume without losing clarity of sound.
Set 'Dynamic' to 'Full', 'Middle' or 'Off' for this effect.
Follow the same procedure as 'Digital Output' to set
the 'Dynamic'.
Preference > Audio
ENTER
Setup menu
Digital Output Full
Dynamic Middle
†
√ Off
Confirm MENU Back SETUP Exit
25